Yamaha DGX-530 Owner's Manual - Page 11
Attach the back board., Put the keyboard on the stand., Post-assembly checklist - stand screws
UPC - 086792880303
View all Yamaha DGX-530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
2 e 6 x 30 mm roundhead screw Setting Up x Attach the back board. Attach the back board, using the 6 x 30 mm roundhead screws e. CAUTION • Be careful not to drop the back board or touch the sharp metal fit- tings. 3-4 r 5 x 16 mm roundhead screws c Put the keyboard on the stand. Check the back-to-front orientation for stand, and carefully place the keyboard on the side boards. Slowly move the keyboard so that the holes on the bottom of the keyboard are properly aligned with the holes on the angle brackets. CAUTION • Be careful not to drop the keyboard or to get your fingers caught between the keyboard and the stand parts. v Install the keyboard to the stand. Fix the keyboard to the angle brackets, using the 5 x 16 mm roundhead screws r. ■ Post-assembly checklist Once you've assembled the stand, check the following points: • Are there any parts left over? ➔ If so, read the assembly instructions again and correct any errors you might have made. • Is the instrument clear of doors and other movable fixtures? ➔ If not, move the instrument to an appropriate location. • Does the instrument make a rattling noise when you play it or move it? ➔ If so, properly tighten all screws. • Also, if the keyboard makes a creaking noise or seems unsteady when you play it, refer carefully to the assembly instructions and diagrams and retighten all screws. DGX-530/YPG-535 Owner's Manual 11