Yamaha HTR-5590 Owner's Manual - Page 25

INTRODUCTION PREPARATION BASIC OPERAIONT Connecting the Power Supply Cords CONNECTIONS I Connecting the AC power cord Plug this unit into the wall outlet. EDANCE SELECTOR T BEFORE POWER ON A OR B: 4ΩMIN. /SPEAKER A+B: 8ΩMIN. /SPEAKER ER : 6ΩMIN. /SPEAKER CENTER: 6ΩMIN. /SPEAKER : 6ΩMIN. /SPEAKER AIN A OR B: 8ΩMIN. /SPEAKER ENTER : 8ΩMIN. /SPEAKER EAR CENTER: 8ΩMIN. /SPEAKER EAR : 8ΩMIN. /SPEAKER AC OUTLETS (U.S.A. and Canada models) To AC outlet Plug in the other components connected to this unit to the wall outlet. I AC OUTLET(S) (SWITCHED) U.S.A., Canada and China models 2 OUTLETS Australia model 1 OUTLET Use these outlets to connect the power cords from your components to this unit. The power to the AC OUTLET(S) is controlled by this unit's STANDBY/ON (or SYSTEM POWER and STANDBY). These outlets will supply power to any connected component whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the AC OUTLET(S) is: U.S.A. and Canada models 80 W China model 50 W Australia model 100 W VOLTAGE SELECTOR VOLTAGE SELECTOR PEDANCE SELECTOR T BEFORE POWER ON N A OR B: 4ΩMIN. /SPEAKER A+B: 8ΩMIN. /SPEAKER TER : 6ΩMIN. /SPEAKER R CENTER: 6ΩMIN. /SPEAKER R : 6ΩMIN. /SPEAKER MAIN A OR B: 8ΩMIN. /SPEAKER A+B: 16ΩMIN. /SPEAKER CENTER : 8ΩMIN. /SPEAKER REAR CENTER: 8ΩMIN. /SPEAKER REAR : 8ΩMIN. /SPEAKER AC OUTLETS I VOLTAGE SELECTOR (China model only) The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local main voltage BEFORE plugging into the AC main supply. Voltages are 110/120/ 220/240 V AC, 50/60 Hz. (China model) ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 21