Yamaha HTR-5590 Owner's Manual - Page 37

INTRODUCTION PREPARATION I Normal Stereo Reproduction Press STEREO/EFFECT to turn off the sound effect for normal stereo reproduction. Press STEREO/EFFECT again to turn the sound effect back on. STEREO EFFECT STEREO or EFFECT Front panel Remote control Notes • If "1B MAIN SP" on the SET MENU is set to "SMALL" and "1E LFE/BASS OUT" is set to "SW", or "1E LFE/BASS OUT" is set to "BOTH", the LFE signals will be output from the subwoofer. • If you turn off the sound effect while a Dolby Digital or DTS signal is being output, the dynamic range of the signal is automatically compressed and the sounds of the center and rear speaker channels are mixed and output from the main speakers. • The volume may be greatly reduced when you turn off the sound effect or if you set "11 D-RANGE" on the SET MENU to MIN. In this case turn on the sound effect. I Displaying the information about the input source You can display the information such as the type, format and sampling frequency of the signal input from the component connected to this unit during stereo reproduction. (While playing a source) 1 Press AMP to select the AMP mode. 2 Press d/u to display the information about the input signal. + TV VOL CH - PRESET TV MUTE SELECT TV VOL - CH + PRESET BASIC PLAYBACK BASIC OPERATION ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 33