Yamaha HTR-5590 Owner's Manual - Page 63

INTRODUCTION PREPARATION BASIC OPERATION I 1F MAIN LEVEL (main level mode) Change this setting if you cannot match the output level of the center, rear (L/R) and rear center speakers with the main speakers because of the unusually high-efficiency performance of the main speakers. Choices: Normal, -10 dB Initial setting: Normal Normal Select this if you can match the output level of your effect speakers with that of your main speakers when using the test tone. 1F MAIN LEVEL SET MENU ZONE B Select this if the speakers connected to the SPEAKERS B terminals are set in the second room. If SPEAKERS A is turned OFF and SPEAKERS B is turned ON, all the effect speakers in the main room are muted and the sound is output only from SPEAKERS B. When a DSP program is selected, this unit automatically enters the Virtual CINEMA DSP mode. If the headphones are connected to PHONES jack on this unit in the Virtual CINEMA DSP mode, this unit enters the SILENT CINEMA DSP mode and the sound is output from both headphones and SPEAKERS B. 1G SP B SET MAIN "ZONE B -/+ : Select / : Exit Normal -10dB -10 dB Select this if you cannot match the output level of your effect speakers with that of your main speakers when using the test tone. 1F MAIN LEVEL Normal -10dB I 1G SP B SET (speaker B set) Use this feature to select the location of the main speakers to be connected to the SPEAKERS B terminals. 2 LOW FRQ TEST Use this feature to adjust the output level of the subwoofer so it matches that of the other speakers in your configuration. Change the setting with the remote control while sitting in the listening position. 1 Press j / i to set "TEST TONE" to ON, and adjust the volume with VOL +/- so you can hear the tone. 2 LOW FRQ TEST ≥ TEST TONE............ON OUTPUT...MAIN L/R FRQ 88Hz Choices: MAIN, ZONE B Initial setting: MAIN MAIN Select this to turn on/off SPEAKERS A and B when the speakers connected to the SPEAKERS B terminals are set in the main room. 1G SP B SET "MAIN ZONE B -/+ : Select / : Exit Notes • Do not turn up the volume too high. • If no test tone is heard, turn down the volume, set this unit in the standby mode and make sure all the necessary connections are correct. 2 Press d to go to "OUTPUT" and press j / i to select the speaker you want to compare with the subwoofer. If SWFR is selected, the test tone above 90 Hz will not be output from the subwoofer. The test tone will not necessarily be output from the selected speakers. The output mode of the test tone depends on the settings of "1 SPEAKER SET" on the SET MENU. 2 LOW FRQ TEST TEST TONE.........OFF ≥ OUTPUT...MAIN L/R FRQ 88Hz ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 59