Yamaha MOX8 Reference Manual - Page 117

VOICE PERF SONG PATTERN MIX MASTER REMOTE UTILITY QUICK SET FILE Part Edit Operation [SONG]/[PATTERN]  Song/Pattern selection  [MIXING]  [EDIT]  Number [1] - [16] [F1] VOICE Determines the Voice for each Part. This display shows only four Parts at a time (Part 1 - 4, Part 5 - 8, Part 9 - 12, or Part 13 - 16). To switch the editable Parts, press the Cursor [] buttons. The editable Parts can be also switched by pressing the corresponding buttons to other Parts of numbers [1] - [16] after pressing the [TRACK] button. [SF1] VOICE Determines the Voice for each Part. Bank Determines the Voice Bank for each Part. For information about settings other than those of the Mixing Voices, see page 7. Number Determines the Voice Program number for each Part. P.WithVce (Parameter with Voice) Determines whether or not the following parameter settings of the selected Voice are copied from the Voice to the current Part when you change a Voice for the current Part individually. • Arpeggio settings • Filter Cutoff Frequency • Filter Resonance • Amplitude EG • Filter EG • Pitch Bend Range (Upper/Lower) • Note Shift NOTE When a Normal Voice is assigned to the Part, the following settings are always copied to the Part regardless of the "P.WithVce" setting. On the other hand, when a Drum Voice is assigned to the part, the following settings are not copied to the part regardless of the "P.WithVce" setting. • "Mono/Poly" • "Switch" (Portamento Part Switch) • "Time" (Portamento Time) • "Mode" (Portamento Mode) Settings: off (not copied), on (copied) [SF2] MODE Mono/Poly Selects monophonic or polyphonic playback for each Part. Monophonic is for single notes only, while polyphonic is for playing multiple simultaneous notes. Settings: mono, poly NOTE This parameter is not available for the Parts to which Drum Voices have been assigned. ReceiveCh (Receive Channel) Determines the MIDI receive channel for the selected Part. Since MIDI data may be coming from many channels at once, you should set this to match the particular channel over which the desired controlling data is being sent. Settings: 1 - 16, off ArpPlyOnly (Arpeggio Play Only) Determines whether or not the current Part plays only the note events of Arpeggio playback. When this parameter is set to on, only the note events of Arpeggio playback affect the tone generator block. Settings: off, on Mixing Mode Mixing Play [F1] VOL/PAN [F2] VOICE [F3] EF SEND [F4] TEMPLATE [F5] VCE ED [F6] EFFECT Mixing Edit Common Edit [F1] GENERAL [F2] MFX [F3] MEQ [F4] USB I/O [F5] A/D IN [F6] EFFECT Part Edit [F1] VOICE [F2] OUTPUT [F3] EQ [F4] TONE [F5] RCV SW Mixing Job [F1] INIT [F2] RECALL [F3] COPY [F4] BULK Mixing Voice Edit Common Edit [F1] GENERAL [F2] OUTPUT [F4] CTL SET [F5] LFO [F6] EFFECT Element Edit [F1] OSC [F2] PITCH [F3] FILTER [F4] AMP [F5] LFO [F6] EQ Mixing Voice Job [F2] RECALL [F3] COPY [F5] DELETE Supplementary Information MOX6/MOX8 Reference Manual 117