Yamaha RM1x Owner's Manual - Page 86
Job 04 Crescendo
View all Yamaha RM1x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
12. Job PATTERN MODE 1. Phrase setting: Phrs Sets the phrase to which adjustment is applied. s Settings : 001 ... 256 2. Segment (M001:1:000 ~ M257: 1:000) Sets the area of the phrase over which adjustment is carried out. The first segment sets the measure, beat, and clock for the start point; the second segment sets the end point. s Settings : Measure: beat : clock 001:1:000 ... 257:1:000 3. Set all Use this parameter if you want to set all targeted notes to some identical gate time (1 to 9999). If you do not want to use this feature (if you want to make the linear adjustment instead), set the value to Off. Note that if the setting is other than Off, the Rate and Offset values are ignored. s Settings: Off (0), 0001 ... 9999 4. Rate The Rate parameter applies a proportional change to the gate timing of all targeted notes. A setting of 100% produces no change; a setting of 50% cuts the gate time in half; a setting of 200% causes the gate time to double. s Settings: 000% ... 100% ... 200% 5. Offset This parameter adds a fixed value to each of the Rateadjusted gate times. A setting of 0 produces no change. Positive values increase the gate time, while negative values decrease it. s Settings: -9999 ... +0000 ... +9999 Original gate timing (Gate) 32 32 32 Offset = -20 (Gate) 12 12 12 Offset = +20 (Gate) 52 52 52 48 48 28 28 68 68 Job 04 Crescendo 1 2 Original gate timing (Gate) 32 32 32 Rate = 50% (Gate) 16 16 16 Rate = 150% (Gate) 48 48 48 3 You use this job to apply a crescendo or decrescendo to the specified range of notes (pitches) in the specified segment of 48 48 the designated track. The RM1x produces the effect by apply- ing a slight velocity adjustment (offset) at the beginning of the segment, with the offset increasing gradually up until the end of the segment. 24 24 1. Phrase setting: Phrs Sets the phrase to which adjustment is applied. s Settings : 001 ... 256 72 72 2. Segment (M001:1:000 ~ M257: 1:000) Sets the area of the phrase over which adjustment is carried out. The first segment sets the measure, beat, and clock for the start point; the second segment sets the end point. s Settings : Measure: beat : clock 001:1:000 ... 257:1:000 3. Velocity Range You use the Velocity Range parameter to set the intensity of the crescendo. This setting selects the value added to the velocities of notes at the final meter and beat of the segment. The RM1x gradually increases the amount added to (or sub- 86 RM1x SEQUENCE REMIXER