Yamaha RM1x Owner's Manual - Page 89
Event
View all Yamaha RM1x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
PATTERN MODE 12. Job Job 09 Chord Separate 1 2 If you wish to move events by one or more full beats or measures, you may find it easier to use the Copy Event job. (below) Note that this job will never move an event past the desig- nated segment's start or end points; any event that would oth- 3 erwise move past this point is instead deposited at the segment's border. This job plays opens each chord formation (within the specified segment of the specified track) into its individual notes, inserting a specified delay between each note. 1. Phrase setting: Phrs Sets the phrase to which adjustment is applied. s Settings : 001 ... 256 If the Clock value is set to 30, a block chord consisting of elements C3, E3, G3 will be played as a C3 (at the chord's original timing) followed 30 cycles later by the E3, and then another 30 cycles later by the G3. This feature is useful, for example, when you want to open up guitar strokes. Note that it is not possible to break chords over the next measure boundary or into the next chord. 1. Phrase setting: Phrs Sets the phrase to which adjustment is applied. s Settings : 001 ... 256 2. Segment (M001:1:000 ~ M257: 1:000) Sets the area of the phrase over which adjustment is carried out. The first segment sets the measure, beat, and clock for the start point; the second segment sets the end point. s Settings : Measure: beat : clock 001:1:000 ... 257:1:000 3. Clock cycles The Clock value sets the number of clock cycles inserted between adjacent chord notes. Note that there are 480 clock cycles per beat. s Settings: 000 ... 999 2. Segment (M001:1:000 ~ M257: 1:000) Sets the area of the phrase over which adjustment is carried out. The first segment sets the measure, beat, and clock for the start point; the second segment sets the end point. s Settings : Measure: beat : clock 001:1:000 ... 257: 1:000 3. Clock The Clock value sets the number of measure, beat, and clock for the data shift. Note that there are 480 cycles per beat. s Settings : Measure: beat : clock 001:1:000 ... 255: 3:479 4. Direction Specifies the direction in which the data will be shifted. "ADVANCE" moves the data toward the beginning of the piece (i.e. notes will sound earlier), while "DELAY" shifts the data toward the end of the piece (i.e. notes will sound later). s Settings : ADVANCE, DELAY Job 11 Copy Event 1 2 t Event Job 10 Shift Clock 1 2 3 4 This job executes a time shift of all data events on the selected segment of the selected track. The shift is executed in clock-cycle increments. 3 4 This job copies all data from a specified source area (phrase) to a specified destination, overwriting any data already exist- ing at the destination. 1. Source phrase The Phrs value selects the track from which the data are copied. s Settings : 001 ... 256 RM1x SEQUENCE REMIXER 89