Yamaha RM1x Owner's Manual - Page 92
Phrase
View all Yamaha RM1x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
12. Job Job 16 Modify Control Data 1 2 Job 17 Time Stretch 1 2 PATTERN MODE 4 5 3 6 Changes or offsets the values of all occurences of the speci- fied type of control change data of the specified segment. 3 This job expands or compresses the timing over the selected segment on the selected phrase. 1. Phrase setting: Phrs Selects the target phrase. s Settings : 001 ... 256 2. Segment (M001:1:000 ~ M257: 1:000) Sets the area of the phrase to be modified. The first segment sets the measure, beat, and clock for the start point; the second segment sets the end point. s Settings : Measure: beat : clock 001:1:000 ... 257:1:000 3. Event Type Selects the event type to be adjusted (at the center of the screen). s Settings : PB (Pitch bend), CC (Any single Control Change message type, 000 to 127), CAT (Channel aftertouch), PAT (Polyphonic aftertouch) 4. Set All Specifies a fixed value to which all occurences of the specified type of control change data will be set. Set this parameter "OFF" if you want to offset the values of the data using the Rate and Offset parameters, below. s Settings : OFF, 000 ... 127, -8192 ... +8191 (Event Type=PB) The operation affects all event timing, note step times, and note gate times. 1. Phrase setting: Phrs Selects the target phrase. s Settings : 001 ... 256 2. Segment (M001:1:000 ~ M257: 1:000) Sets the target area of the phrase. The first segment sets the measure, beat, and clock for the start point; the second segment sets the end point. s Settings : Measure: beat: clock 001:1:000 ... 257:1:000 3. Time The Time parameter sets the time multiplier. s Settings : 025% ... 400% t Phrase Job 18 Copy Phrase 1 2 5. Rate Sets the ratio between the lower and higher control change values. A setting of "100%" maintains the original relationship between the control values, lower settings produce a narrower range, and higher values produce a wider range. s Settings : 000 ... 200 6. Offset Determines the amount of offset applied to the control change values. "-" settings reduce the values while "+" settings increase the values. New Control Change Values = Original Control Change Values x rate/100 + offset (If the right side of the equation is less than 0, the new value becomes 1) s Settings : -127 ... 127, -8192 ... +8191 (Event Type=PB) 92 RM1x SEQUENCE REMIXER 3 4 This job copies a selected phrase (either user phrase or preset phrase) to the designated user phrase. The source-side Style parameter is meaningful only if you are copying from a user phrase. If the destination phrase does not yet exist, this job will create it. If it does exist, the job will delete its original data. 1. Source style The upper Style value selects the style containing the user phrase to be copied. The value is meaningful only if you are copying a user phrase; the RM1x ignores the setting if you are copying a preset phrase. s Settings : U01 ... U50 P01 .... P60