Yamaha YSP-5100BL Owners Manual - Page 15
Changing OSD language, AUTO SETUP (IntelliBeam), Installing the IntelliBeam microphone, microphone - speaker system
View all Yamaha YSP-5100BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
INTRODUCTION PREPARATION PLAYBACK FEATURES Changing OSD language You can select an OSD language among English, German, French, Spanish, Italian, Dutch and Russian. Before operating the following steps, select this unit as the video input on your TV. p p 1 Press and hold ISETUP until the "LANGUAGE SETUP" menu appears on your TV. 3)LANGUAGE SETUP . ENGLISH DEUTSCH Francais ESPANOL ITALIANO NEDERLANDS [ ]/[ ]:Up/Down [ENTER]:Enter 2 Press G / to select the desired language and then press GENTER. Choices: ENGLISH (English), DEUTSCH (German), Français (French), ESPAÑOL (Spanish), ITALIANO (Italian), NEDERLANDS (Dutch Russian) Initial setting: ENGLISH (English) 3 To exit from the menu, press ISETUP. Changing OSD language AUTO SETUP (IntelliBeam) Using the system memory AUTO SETUP (IntelliBeam) This unit creates a sound field by reflecting sound beams off the walls of your listening room and by broadening the cohesion of all the channels. Just as you would arrange the speaker position of other audio systems, you need to set the beam angle to enjoy the best possible sound from this unit. Notes • After you have completed the AUTO SETUP procedure, be sure to disconnect the IntelliBeam microphone. • The IntelliBeam microphone is sensitive to heat. - Keep the IntelliBeam microphone away from direct sunlight. - Do not place the IntelliBeam microphone on top of this unit. • You cannot use the AUTO SETUP when "PREOUT" is selected in "SOUND OUT" (page 38). • You cannot run the AUTO SETUP while playing back the iPod/iPhone by using PDX-50TX. To run the AUTO SETUP, stop playback and then disconnect the iPod/iPhone from PDX-50TX. About PDX-50TX, refer to "Safety and Accessory Information" (separate booklet). Installing the IntelliBeam microphone Follow the procedure below to connect the IntelliBeam microphone to this unit and place it in a proper location. 1 Connect the supplied IntelliBeam microphone to the INTELLIBEAM MIC jack on the front panel. y • Use the supplied cardboard microphone stand or a tripod to place the IntelliBeam microphone at the same height as your ears would be when you are seated. IntelliBeam microphone Center height of this unit Upper limit Within 1 m (3.3 ft) INPUT VOLUME INTELLIBEAM MIC Cardboard microphone stand 1.8 m (6.0 ft) or more Within 1 m (3.3 ft) Listening position Lower limit SETTINGS INTELLIBEAM MIC 2 Place the IntelliBeam microphone on a flat level surface at your normal listening position. Place the IntelliBeam microphone on the extended center line of this unit and 1.8 m (6.0 ft) or more away from it. Also, make sure place the IntelliBeam microphone within 1 m (3.3 ft) upper or lower from the center height of this unit. Center line Cardboard microphone stand IntelliBeam microphone APPENDIX 15 En