Yamaha YSP-5100BL Owners Manual - Page 18
Error messages for AUTO SETUP, Error message, Cause, Remedy
View all Yamaha YSP-5100BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
TV AV TV AUX 1 AUX 2 HDMI 1 HDMI 2 HDMI 3 HDMI 4 iPod RADIO MOVIE ENTER MUSIC TAINMENT OFF CINEMA DSP SURROUND STEREO ENTER TOP MENU OPTION SETUP MENU RETURN TV VOL CH VOLUME G I TV MUTE TV INPUT MUTE UNIVOLUME SUR. DECODE INTELLIBEAM 1 2 3 4 5 6 7 8 9 0 +10 ENT CODE SET TUNING PRESET CATEGORY INFO MEMORY SLEEP ■ Error messages for AUTO SETUP If an error message is displayed on your TV, check the error message list to solve the problem and then follow the procedure below. [ERROR E-1]: Press GENTER to run the AUTO SETUP procedure again or IRETURN to cancel the operation Other errors: Press IRETURN to cancel the operation and then run the AUTO SETUP procedure again. Note If the problem is difficult to be solved, configure the settings manually in "MANUAL SETUP" (page 34). Error message Cause Remedy ERROR E-1 There is too much unwanted noise in Please test in quieter environment. your listening room. Make sure that your listening room is as quiet as possible. You may want to choose certain hours during the day when there is not much noise coming from outside. ERROR E-2 No MIC detected. Please check MIC connection and re-try. The IntelliBeam microphone is not connected to this unit or disconnected during the AUTO SETUP procedure. Connect the IntelliBeam microphone to this unit firmly. ERROR E-3 Unexpected control is detected. Please re-try. Some other operations were performed on this unit while the AUTO SETUP procedure was in progress. Do not perform any other operations while the AUTO SETUP procedure is in progress. ERROR E-4 Please check MIC position. MIC should be set in front of the unit and re-try. The IntelliBeam microphone is not placed in front of this unit. Make sure that the IntelliBeam microphone is installed in front of this unit. ERROR E-5 Please check MIC position. MIC should be set above 1.8m/6.0ft and re-try. The IntelliBeam microphone is not placed in the right distance from this unit. Make sure that the IntelliBeam microphone is installed more than 1.8 m (6.0 ft) from the front of this unit and within 1 m (3.3 ft) from the center height of this unit. ERROR E-6 Volume level is lower than expected. Please check MIC position/connection and re-try. The IntelliBeam microphone cannot collect the sound produced by this unit because the sound output level is too low. Make sure that the IntelliBeam microphone is firmly connected to this unit and placed in a proper location. If the problem persists, contact the nearest authorized Yamaha service center for assistance. ERROR E-7 Unexpected error happened. Please re-try. An internal system error occurred. Repeat the AUTO SETUP procedure. See page - 15 - 15 15 15 - GENTER G / IRETURN ISETUP 18 En