Yamaha YSP-5100BL Owners Manual - Page 34

TV AV TV AUX 1 AUX 2 HDMI 1 HDMI 2 HDMI 3 HDMI 4 iPod RADIO MOVIE ENTER MUSIC TAINMENT OFF CINEMA DSP SURROUND STEREO D ENTER TOP MENU OPTION SETUP MENU RETURN TV VOL CH VOLUME G I TV MUTE TV INPUT MUTE UNIVOLUME SUR. DECODE INTELLIBEAM 1 2 3 4 5 6 7 8 9 0 +10 ENT CODE SET TUNING PRESET CATEGORY INFO MEMORY SLEEP DInput selector keys GENTER G / // G / G IRETURN ISETUP 34 En p Basic SET MENU operation 1 Press ISETUP. SET MENU . ;MEMORY ;AUTO SETUP ;MANUAL SETUP ;SOUND SET MENU ;SOUND OUT MENU ;INPUT MENU ;DISPLAY MENU [ ]/[ ]:Up/Down [ENTER]:Enter p 1 In "SETTING PARAMETERS 1/3", configure "INSTALLED POSITION". Select the installed position of this unit. Choices: FLAT TO WALL* (parallel to wall), ANGLE TO WALL OR CORNER (angle to wall or corner) FLAT TO WALL ANGLE TO WALL OR CORNER p p 2 Press G / to select the desired menu and then press GENTER. C)MANUAL SETUP .1)SETTING PARAMETERS 2)BEAM ADJUSTMENT 3)IMAGE LOCATION [ ]/[ ]:Up/Down [ENTER]:Enter Note • If you change this setting, "BEAM MODE" setting changes automatically (page 23). 2 Configure "INSTALLED HEIGHT". Specify the installed height of this unit. Control range: 0.0 m to 3.0 m (0.0 ft to 10.0 ft) Initial setting: 1.0 m (3.5 ft) y • To return to the previous menu, press IRETURN. 3 Press G / / / and GENTER to configure each parameter. y • The initial settings are marked with "*". Note • The menu screen disappears if one of the DInput selector keys is pressed while the SET MENU is being configured. 4 To exit from the menu, press ISETUP. MANUAL SETUP Use this menu to manually adjust the parameters related to the sound beam output. To fine-adjust parameters configured by AUTO SETUP, use "BEAM ADJUSTMENT" and "IMAGE LOCATION". ■ SETTING PARAMETERS (Setting parameters) SET MENU → MANUAL SETUP → SETTING PARAMETERS Use to set the position of this unit in your listening room and the distance of this unit from the listening position. y • If you make adjustments in "SETTING PARAMETERS", the "BEAM ADJUSTMENT" parameters are automatically adjusted. Note • If you make adjustments in "SETTING PARAMETERS", the beam optimization settings made in the AUTO SETUP procedure will be lost. 0.0 to 3.0 m (0.0 ft to 10.0 ft) y • Press G to proceed to the next page. 3 In "SETTING PARAMETERS 2/3", configure the listening room settings. Specify the length and width of the listening room. Control range: 2.0 m to 12.0 m (6.5 ft to 40.0 ft) When this unit is installed parallel to wall, specify the width of the listening room and the distance between this unit and rear wall. When this unit is installed at the corner of the room, specify the width of length of the listening room. 4 In "SETTING PARAMETERS 3/3", configure the distance settings. Specify the distance between the listening position and this unit. When this unit is installed parallel to wall, you also need to specify the distance between the listening position and left wall.