Yamaha YSP-5100BL Owners Manual - Page 35
BEAM ADJUSTMENT Beam adjustment, IMAGE LOCATION Image location, Con BEAM TRAVEL LENGTH.
View all Yamaha YSP-5100BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
INTRODUCTION Control range (from this unit): 1.8 m to 9.0 m (6.0 ft to 30.0 ft) Control range (from left wall): 0.6 m to 11.4 m (2.0 ft to 38.0 ft) FLAT TO WALL 1.8 to 9.0 m (6.0 to 30.0 ft) 0.6 to 11.4 m (2.0 to 38.0 ft) 3 Configure "BEAM TRAVEL LENGTH". Adjust the distance that sound beams travel after being output and reflected off the wall until they arrive at the listening position so that all sounds can arrive at the listening position at the same time. Note • Configure this setting only when you have adjusted "HORIZONTAL ANGLE". Control range: 0.3 m to 24.0 m (1.0 ft to 80.0 ft) PREPARATION PLAYBACK FEATURES ■ BEAM ADJUSTMENT (Beam adjustment) SET MENU → MANUAL SETUP → BEAM ADJUSTMENT Use to manually adjust the various sound beam settings. Notes • The "BEAM ADJUSTMENT" parameters are automatically adjusted (except "Center" in "FOCAL LENGTH") if you run the AUTO SETUP (page 15) or if you configure "SETTING PARAMETERS" (page 34). • Depending on the beam mode settings (page 23), some channel positions may not be available for selection. In this case, "- -" is displayed. • If you change "BEAM ADJUSTMENT" settings while playing back your iPod/iPhone connected to PDX-50TX, the subwoofer connected to SWK-W10 outputs the iPod/iPhone audio. We recommend stopping the iPod/iPhone playback during the beam adjustment. The length of each arrow indicates the beam travel length. 4 Configure "FOCAL LENGTH". Adjust the distance from the front of this unit to the focal point of output for each channel to achieve an expansive feeling for each channel. Adjust toward (minus) to move the focus outward (widen the sweet spot) and adjust toward + (plus) to move the focus toward the normal position (narrow the sweet spot). Focal point Focal length 1 Configure "HORIZONTAL ANGLE". Adjust the horizontal angle of sound beams for each channel using test tones. Adjust toward L (left) to move the direction of the output to the left and adjust toward R (right) to move it to the right. Control range: L90° to R90° (-) (+) (+) (-) Sweet spot Control range: -1.0 m to +13.0 m (-3.5 ft to +43.5 ft) y • We recommend that you use the initial setting (-0.5 m or - 1.5 ft) for "Center". • The width of the sweet spot becomes slightly wider than the width of this unit if you run the AUTO SETUP (page 15) or if you configure "SETTING PARAMETERS" (page 34). Example Front left channel Center channel Customizing this unit (SET MENU) System configurations (ADVANCED SETUP) y • Press G to switch the channels. 2 Configure "VERTICAL ANGLE". Adjust the vertical angle of sound beams for each channel using test tones. Adjust toward - (minus) to move the angle downward and adjust toward + (plus) to move the angle upward. Control range: -45° to +45° (+) 0° (-) ■ IMAGE LOCATION (Image location) SET MENU → MANUAL SETUP → IMAGE LOCATION Use to adjust the direction from which the front left and right channel sound is heard so that each sound can be heard closer to the center channel. Use this feature to redirect audio signals if the sound coming from the front left and right channels seems unnatural. Using an external amplifier Controlling external components 35 En SETTINGS APPENDIX