Yamaha YSP-5100BL Owners Manual - Page 44

Problem Cause Remedy Surround sound effects are insubstantial. The listening room is not a regular shape. Install this unit in a square or rectangular shaped room. There is no wall in the path of the sound beam. Try placing a flat object, such as a board, in the path of the sound beam. Digital audio signals cannot be played back. (q DIGITAL indicator does not light up in the front panel display.) The playback component is connected to this unit with an analog connection. The external component is not set to output digital audio signals. Connect them with an HDMI connection or a digital connection. Refer to the owner's manual supplied with your component and check the setting. Bit streaming is disabled on the external component. Refer to the owner's manual supplied with your component and check the setting. There is noise interference when a subwoofer is not connected to this unit. The protection circuitry was in operation because a source with strong bass elements was played back. Turn down the volume level. Set "BASS OUT" to "SUBWOOFER" in "SUBWOOFER SET". Connect a subwoofer and adjust settings for "SUBWOOFER SET". On-screen display does not appear. The cable is not connected to the TV or this unit properly. Connect the cable properly. The HDMI control function does not work properly. "HDMI CONTROL" is set to "OFF" in "SET MENU". Set "HDMI CONTROL" to "ON" in "SET MENU". The HDMI control function is disabled on your TV. Refer to the owner's manual supplied with your TV and check the setting. The number of the connected HDMI components is over the limit. Disconnect some of the HDMI components. The automatic lipsync is not effective even "AUTO LIP SYNC" is set to "ON". The TV does not support the automatic lipsync. Set "AUTO LIP SYNC" to "OFF" and then manually adjust the audio output delay. "Not Available" appears on the front panel display after key operation. The key is unable to function in the current condition. See page - - 12 - - 21 36 36 12 39 - - 36 - ■ FM tuner Problem FM stereo reception is noisy. Cause The characteristics of FM stereo broadcasts may cause this problem when the transmitter is too far away or the antenna input is poor. There is distortion, and clear reception cannot be obtained even with a good FM antenna. There is multi-path interference. The desired station cannot be tuned into with the automatic tuning method. The signal is too weak. Previously preset stations can no This unit has been disconnected for a long period. longer be tuned into. Remedy Check the antenna connections. Try using a high-quality directional FM antenna. Use the manual tuning method. Adjust the antenna position to eliminate multi-path interference. Use a high-quality directional FM antenna. Use the manual tuning method. Preset the stations again. See page 14 - 25 - - 25 25 ■ SIRIUS Satellite Radio Status message ANTENNA ERR SIRIUS LOADING CHECK TUNER Cause The antenna is not connected to the SiriusConnect tuner properly. This unit is communicating with the SiriusConnect tuner. The SiriusConnect tuner is not connected to the SIRIUS jack of this unit correctly. The SiriusConnect tuner is not connected to the AC wall outlet. Remedy Check the connection of the antenna and SiriusConnect tuner. The message disappears normally within several tens of seconds. Check the connection of the SiriusConnect tuner and this unit. Connect the power cable of the SiriusConnect tuner to the AC wall outlet. See page 26 - 26 26 44 En