Yamaha YSP-5100BL Owners Manual - Page 41

INTRODUCTION PREPARATION R.INPUT POWER (Power-on by remote control input keys) Select whether or not to automatically turn on this unit when you select an input source on the remote control. To enable the function, select "R.INPUT PW: ON". Choices: R.INPUT PW: OFF*, R.INPUT PW: ON AC ON STANDBY (Standby after AC on) Set this unit to the standby mode when the AC power is recovered after the power to this unit was lost temporally (disconnect the AC power plug from the wall outlet, power outage, etc.). To enable the function, select "AC STANDBY: ON". Choices: AC STANDBY: OFF*, AC STANDBY: ON SIRIUS PIN (SIRIUS Satellite Radio PIN) Reset the Parental Lock cord for SIRIUS Satellite Radio. Choices: CANCEL*, RESET MEMORY PROTECT (Memory protect) Protect the settings you have saved in the system memory. To protect the settings, select "PROTECT: ON". Choices: PROTECT: OFF*, PROTECT: ON DEMO MODE (Demo mode) Test the sound beam output from this unit to experience the sound beam. To set this unit to the demo mode, select "BEAM DEMO: ON". Choices: BEAM DEMO: OFF*, BEAM DEMO: ON • To move the beam horizontally, turn off this unit and then turn on it again ("DEMO" appears on the front panel display). Playback an input source and then press EOFF. • To stop the beam movement, press EOFF again. • To adjust the beam angle manually, press FSURROUND or FSTEREO when the beam is not moving. y • After you checked the sound beam output, set this setting to "BEAM DEMO: OFF". • If you set "SOUND OUT" to "PRE OUT", "DEMO MODE" does not function. FACTORY PRESET (Factory preset) Reset all of the parameters of this unit to the factory presets. Choices: CANCEL*, RESET PLAYBACK FEATURES Using an external amplifier You can connect an external amplifier to the PRE OUT jacks. Set "SOUND OUT" (page 37) to "PRE OUT" and then configure "PRE OUT BASS Management" parameters. See also: "Changing the audio output method for surround playback" (page 23) 1234 SETTINGS FRONT SURROUND SUR. BACK PRE OUT 5 1 FRONT PRE OUT jacks Output front right and left channel signals. 2 SURROUND PRE OUT jacks Output surround right and left channel signals. 3 SUR. BACK PRE OUT jacks Output surround back right and left channel signals. 4 CENTER PRE OUT jack Outputs center channel signals. 5 SUBWOOFER PRE OUT jack Connect a subwoofer with a built-in amplifier. Note • The following functions are disabled when an external amplifier is used. - AUTO SETUP (page 15) - CINEMA DSP programs (page 22) - UniVolume (page 31) - MUSIC ENHANCER (page 37) - BASS EXTENSION (page 37) - Adaptive DRC (page 37) Customizing this unit (SET MENU) System configurations (ADVANCED SETUP) Using an external amplifier Controlling external components 41 En APPENDIX