Yamaha YSP 900 Owner's Manual - Page 36
SHOW RESULT, Disconnect the optimizer microphone
UPC - 027108928302
View all Yamaha YSP 900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
AUTO SETUP (IntelliBeam) 8 Check that the following screen is displayed on your TV. The results of the AUTO SETUP procedure are displayed on your TV. Example 1 SHOW RESULT MEASUREMENT COMPLETE BEAM MODE :5 BEAM SUBWOOFER :NOT APPLICABLE [ENTER]:Save set-up. [RETURN]:Do not save set-up. 10 Disconnect the optimizer microphone from the OPTIMIZER MIC jack on the front panel. OPTIMIZER MIC Example 2 SHOW RESULT MEASUREMENT COMPLETE ENVIRONMENT CHECK[FAILED] BEAM MODE :5 BEAM SUBWOOFER :YES [ENTER]:Save set-up. [RETURN]:Do not save set-up. y • If ''ENVIRONMENT CHECK [FAILED]'' is displayed, we recommend running the AUTO SETUP procedure again. For details, see step 9. • If ''SUBWOOFER : NOT APPLICABLE'' is displayed even though a subwoofer is connected to this unit, increase the volume level of the subwoofer and run the AUTO SETUP procedure again. • Depending on the environment of your listening room, the beam angle of front left and right, and surround left and right may be set to the same value even if 5BEAM is displayed as a result. 9 Press ENTER to confirm the results or press RETURN to cancel the results. The following screen is displayed temporarily for 2 seconds and then disappears from your TV. ENTER AUTO SETUP COMPLETE Please remove the MIC from the YSP and the listening position. If ''ENVIRONMENT CHECK [FAILED]'' is displayed in step 8, the following screen is displayed after pressing ENTER. In this case, see ERROR E-1 in "Error messages for AUTO SETUP" on page 33. Press ENTER to exit the AUTO SETUP and then run the procedure again from step 3. AUTO SETUP COMPLETE Your YSP unit may not be set up correctly. We recommend you try again. Please press [ENTER] key to exit. 32 En