Yamaha YSP 900 Owner's Manual - Page 79
Setting the FACTORY PRESET, FACTORY PRESET
UPC - 027108928302
View all Yamaha YSP 900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
4 Press / to switch between DEMO: ON and DEMO: OFF. ENTER VOL DEMO: ON ADJUSTING SYSTEM PARAMETERS Setting the FACTORY PRESET You can reset all of the parameters of this unit to the factory presets. This procedure completely resets ALL the parameters in SET MENU. Note After performing the following procedure you must run the AUTO SETUP again to match your surround sound environment. 1 Repeat steps 1 to 3 in "Using the system parameters" on page 72. 2 Set the operation mode selector to YSP to switch to the operation mode of this unit. TV/AV YSP VOL DEMO: OFF • Select DEMO: ON to activate the demo mode. • Select DEMO: OFF to deactivate the demo mode. 3 Press / on the remote control so that FACTORY PRESET is shown in the front panel display. 5 Press STANDBY/ON on the front panel to set this unit to the standby mode. ENTER STANDBY/ON The new setting will be activated when you turn on the power of this unit next time. Press ENTER to test the sound beam. The sound beam being output shuttles between left and right. Press ENTER again to stop shuttling. VOL FACTORY PRESET 4 Press ENTER. ENTER ADVANCED OPERATION English 75 En