Zenith H20H52DT Operating Guide - Page 39

LT2000 QuickSet Programmer Use the Zenith LT2000 QuickSet II "Clone" Programmer to copy the setup from a "master" TV then quickly transfer the setup to duplicate TVs must be the same model number as the master TV. THE CLONE HAS CONTROL OF THE TV THE CLONE IS VERSION XX THE TV IS VERSION XX THE SW IS REVISION XX CLONE CLOCK = XX:XX TV CLOCK = XX:XX -PRESS ANY KEY TO CONTINUE. -DISCONNECT CLONE WHEN DONE. Learn Master TV Typical MPI Connections Teach Other TV Typical MPI Connections Antenna TV Back Antenna TV Back RF Coaxial Wire (75 ohm) ANTENNA CABLE TV SPEAKER M.P.I. PILLOW SPEAKER VIDEO IN SPEAKER OUT AUDIO IN TV Back Panel (Expanded View) RF Coaxial Wire (75 ohm) ANTENNA CABLE TV SPEAKER M.P.I. PILLOW SPEAKER VIDEO IN SPEAKER OUT AUDIO IN TV Back Panel (Expanded View) Connect cable to TV MPI Jack and follow on-screen instructions MPI Status Indicator Reset Color green battery OK red battery low Blink pattern slow power on no communications heart beat power on communications OK QuickSet II Programmer LT2000 ZENITH ELECTRONICS CORPORATION, GLENVIEW, ILLINOIS USA Clone Connect cable to TV MPI Jack and follow on-screen instructions MPI Status Indicator Reset Color green battery OK red battery low Blink pattern slow power on no communications heart beat power on communications OK QuickSet II Programmer LT2000 ZENITH ELECTRONICS CORPORATION, GLENVIEW, ILLINOIS USA Clone The optional QuickSet II Clone Programmer (LT2000) allows custom setup and programming information to be quickly copied from a master TV into multiple identical television sets. Once learned from the master, setup data is retained in the LT2000 for future use. When using the LT2000, cloning operations will go easier if the TV set is connected to a good quality signal and operating with a stable picture displayed. To operate the LT2000, use the indicated keys on an HP602, LP702, or MBR3447 remote, or the front panel keys on the TV receiver. Page 39