Zenith H20H52DT Operating Guide - Page 5

TABLE OF CONTENTS Use the steps outlined below as a setup guide and to determine the TV features that will require adjustment for the needs of the end user. Safety Warnings 2 Important Safety Instructions 3 - 4 Table of Contents 5 Step 1. Hook Up the HealthViewTV TV and other Equipment Hookups Antenna 6 Cable Service 7 Antenna with VCR 8 Cable service with VCR 9 External Speaker Connection (8-ohm output) 9 Pillow Speaker 10 Step 2. Channel Search and Reception Setup Auto Program 11 (Select Antenna, or cable service then do channel search) Front Panel Controls 12 Optional Installer's Remote Key Functions 13 On-Screen Menus Overview 14 Step 3. Customize the TV's Features Setup Menu (Start with page 11, Auto Program) Descriptions of the menus on the TV 15 Setting Add/Del/Blank 16 Clock Set 18 Setting On/Off Timers Captions (Caption/Text) Language Video Menu FM Radio Menus Installer Parental Control Menu Other Menus and On-Screen Displays Managing the Channel Banks Installer Menus LT2000 Quickset II Clone Programmer 17 19 21 22 23 - 24 25 - 26 27 28 - 30 31 - 38 39 - 43 Patient Operation Section (Copy for patient usage) Optional Patient Remote Key Functions 44 Optional Patient Remote Key Functions - FM Radio 45 Patient Parental Control Menu 46 - 47 Patient Menus and On-Screen Displays 48 Maintenance 49 Troubleshooting 50 Glossary 51 Warranty for HealthView Series TVs Back Cover Optional Installer and Patient Remote Controls: Shown herein are optional remote controls that can be used by the installer and the patient. Be advise that these remote controls are NOT included with this TV. However, these remotes can be purchased separately, see your Zenith Electronics dealer. Installer/Hospital Note: Pages 44, 45, 46, 47 and 48 contain information and menus which the patient can use to operate the TV. It is recommended that these four pages be copied and included with the literature packet that the hospital provides to the patient. Purchase the Optional Installer's Remote and Clone Programmer To perform a normal installation set up, you need an installer's remote such as the HP602, and the LT2000 Quickset II Clone Programmer-both are shown and described in later sections. The installer remote allows access to the Installer menus, User menus, and Source/Channel Bank keys. The installer remote has Menu, Select, and Adjust, and Channel Bank Keys. The LT2000 Quickset II Clone Programmer is used to duplicate a TV's setup and install it on another identical TV. See your Zenith Dealer. Design and specifications subject to change without prior notice. Page 5