Zenith H20H52DT Operating Guide - Page 6

Antenna Hook Up Connect an off-air antenna to the HealthView TV. 1 Locate the Antenna/Cable jack on the back of the HealthView TV. Connect the antenna wire that runs from 2 the wall to this jack, according to one of the diagrams shown to the right. Remove the back of the optional remote 3 and put in two AA batteries. Antenna Flat wire (300 ohm) Back of Remote Plug in the TV. The HealthView TV is 4 designed to operate on standard current, 120-volt 60 Hertz AC. Do not attempt to operate it on DC Power. 5 Go to page 11 to Auto Program the TV. 300/75 ohm Adapter Antenna If you have a 75 ohm RF cable, then you don't need any adapters. A 300 to 75 ohm adapter is not included with the Zenith HealthView TV. RF Coaxial Wire (75 ohm) TV Back ANTENNA CABLE TV SPEAKER M.P.I. PILLOW SPEAKER VIDEO IN SPEAKER OUT AUDIO IN TV Back Panel (Expanded View) TV Back ANTENNA CABLE TV SPEAKER M.P.I. PILLOW SPEAKER VIDEO IN SPEAKER OUT AUDIO IN TV Back Panel (Expanded View) Mini Glossary 75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking through the middle, and it screws onto the threaded jack on the back of the TV. 300 TO 75 OHM ADAPTER A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws on one end and a round opening with a wire sticking out on the other end. Page 6