Zenith XBR413 Operating Guide - Page 56

Troubleshooting (Continued) Symptom Cannot record or did not record successfully. Timer Recording not possible. Cause The remaining blank space on the disc is insufficient. The source you are trying to record is copyprotected. When setting the recording channel, the channel is tuned on the TV's own tuner. When recording to a Video mode disc, programs that are copy-once protected cannot be recorded. Clock in VCR/DVD Recorder is not set to correct time. Stereo Audio Record and/or Playback not present. Remote control does not work properly. Timer has been programmed incorrectly. TIMER indicator light does not appear after programming timer. TV is not Stereo-compatible. Broadcast program is not in stereo format. VCR/DVD Recorder A/V Out jacks are not connected to TV A/V In jacks. VCR/DVD Recorder Audio/Video Out is not selected for viewing at the TV. VCR/DVD Recorder's TV audio channel is set to SAP or MONO. The remote control is not pointed at the remote sensor of the VCR/DVD Recorder. The remote control is too far from the VCR/DVD Recorder. There is an obstacle in the path of the remote control and the VCR/DVD Recorder. The batteries in the remote control are exhausted. Solution Use another disc. You cannot record the source. Select the channel on the VCR/DVD Recorder's built-in TV tuner. Use a VR mode formatted disc for copy-once material. Set clock to correct time. See "Clock (Auto)" or "Clock (Manual)" on page 19. Reprogram Timer. See "Timer Recording" on page 41. Reprogram Timer. No solution. No solution. Make A/V connections. Stereo is available only via A/V output from VCR/DVD Recorder. Select AUX or A/V source as TV input. Set TV audio channel mode to Stereo. See "Changing TV Audio Channel" on page 27. Point the remote control at the remote sensor of the VCR/DVD Recorder. Operate the remote control within 23 ft (7 m). Remove the obstacle. Replace the batteries with new ones. Moisture Condensation Moisture condensation can occur: • When the VCR/DVD Recorder is moved from a cold place to a warm place. • Under extremely humid conditions. In locations where moisture condensation may occur: • Keep the VCR/DVD Recorder plugged into an AC power outlet with POWER On. This will help prevent condensation. • When condensation has occurred, wait a few hours for the VCR/DVD Recorder to dry before using it. Reset the VCR/DVD Recorder If you observe any of the following symptoms... When the VCR/DVD Recorder is plugged in, but the power will not turn on or off. When the display window does not working. When the VCR/DVD Recorder does not operate normally. You can reset the VCR/DVD Recorder as follows : Press and hold the POWER button for more than five seconds. This will force the VCR/DVD Recorder to power off. . Press the POWER button again to turn the VCR/DVD Recorder back on. Unplug the power cord and then plug the power cord again after more than five seconds. 56