ZyXEL NBG-460N User Guide - Page 193
Label, Description
View all ZyXEL NBG-460N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 193 highlights
Chapter 15 IPSec VPN Table 65 Security > VPN > General > Rule Setup: IKE (Basic) (continued) LABEL DESCRIPTION Local Content When you select IP in the Local ID Type field, type the IP address of your computer in the Local Content field. The NBG-460N automatically uses the IP address in the My IP Address field (refer to the My IP Address field description) if you configure the Local Content field to 0.0.0.0 or leave it blank. It is recommended that you type an IP address other than 0.0.0.0 in the Local Content field or use the Domain Name or E-mail ID type in the following situations. • When there is a NAT router between the two IPSec routers. • When you want the remote IPSec router to be able to distinguish between VPN connection requests that come in from IPSec routers with dynamic WAN IP addresses. When you select Domain Name or E-mail in the Local ID Type field, type a domain name or e-mail address by which to identify this NBG460N in the Local Content field. Use up to 31 ASCII characters including spaces, although trailing spaces are truncated. The domain name or e-mail address is for identification purposes only and can be any string. Secure Gateway Type the WAN IP address or the domain name (up to 31 characters) of Address the IPSec router with which you're making the VPN connection. Peer ID Type Select IP to identify the remote IPSec router by its IP address. Select Domain Name to identify the remote IPSec router by a domain name. Peer Content Select E-mail to identify the remote IPSec router by an e-mail address. The configuration of the peer content depends on the peer ID type. For IP, type the IP address of the computer with which you will make the VPN connection. If you configure this field to 0.0.0.0 or leave it blank, the NBG-460N will use the address in the Secure Gateway Address field (refer to the Secure Gateway Address field description). For Domain Name or E-mail, type a domain name or e-mail address by which to identify the remote IPSec router. Use up to 31 ASCII characters including spaces, although trailing spaces are truncated. The domain name or e-mail address is for identification purposes only and can be any string. It is recommended that you type an IP address other than 0.0.0.0 or use the Domain Name or E-mail ID type in the following situations: • When there is a NAT router between the two IPSec routers. • When you want the NBG-460N to distinguish between VPN connection requests that come in from remote IPSec routers with dynamic WAN IP addresses. IPSec Algorithm Encapsulation Mode Select Tunnel mode or Transport mode from the drop-down list box. NBG-460N User's Guide 193