1994 Chevrolet Suburban Owner's Manual - Page 297

Front Parkingnurn Signal Lights with Sealed Beam Headlights 1. Remove the two screws at the inside edge of the parkinghurn signal light assembly. 2. Remove the light assembly by swinging it out from the inside edge and sliding it out at the outside edge. 3. Squeeze the tab on the side of the light socket while turning the socket to the left. 4. Pull the socket out of the light assembly. 5. Push in gently on thebulb, turn it to the left and remove it from the socket. 6. Put the new bulb in the socket, gently press in on the bulb and turn it to the right until it is tight. 7. Put the socket back into the light assembly and turn it socket to the right until it locks. 8. Put the parkinghrn signal light assembly back into the vehicle and tighten the screws. Front Parkingnurn Signal Lights with Composite Headlights 1. Removethe screws and take out the parkinghum signal light assembly. 2. Squeeze the tab on the side of the light socket while turning the socket to the left. 6-52