1994 Chevrolet Suburban Owner's Manual - Page 96

For a single wiping cycle, turn the band to MIST. Hold it there until the wipers start, then let go. The wipers will stop after one cycle. If you want more cycles, hold the band on MIST longer. You can set the wiper speed for a long or short delay between wipes. This can bevery useful in light rain or snow. Turn the band to choose the delay time. The closer to LO, the shorter the delay. For steady wiping at low speed, turn the band to the LO position. For high speed wiping, turn the band further, toHI. To stop the wipers, move the band to the off symbol. Heavy snow or icecan overload your wipers. The windshield wiper motor is protected from overload by a circuit breaker and a fuse. If the motor overheats due toheavy snow, etc., the wiper will stop until the motor cools. Although the circuit is protected from electrical overload, overload due to heavy snow, etc. maycause wiper linkage damage. Always clear ice and heavy snow from the windshield before using your windshield wipers. Windshield Washer At the top of the lever there's a paddle with the word PUSH on it. To spray washer fluid on the windshield, push the paddle. 0- Washer fluid will spray as long as you push the paddle. When you let go of the paddle, the wipers will continue to wipe for a few seconds and then either stop orreturn to the preset speed. Driving without washer fluidcan be dangerous. A bad mud splash can block your vision. You could hit another vehicle or go off the road. Check your washer fluid level often. 2-41