2011 Chevrolet Volt Owner's Manual - Page 279

Infotainment System Using the "Digit Dial" Command The digit dial command allows a phone number to be dialed by entering the number one at a time. After each number is entered, the system repeats back the number it heard followed by a tone. If an unwanted number is recognized by the system, say "Clear" at any time to clear the last number. To hear all of the numbers recognized by the system, say "Verify" at any time. 1. Press b g. Say "Hands Free" after the tone. 2. Say "Digit Dial." 3. Say each digit, one at a time, that you want to dial. After each digit is entered, the system repeats back the digit it heard followed by a tone. After the last digit has been entered, say "Dial." Once connected, the person called will be heard through the audio speakers. Using the "Re‐dial" Command 1. Press b g. Say "Hands Free" after the tone. 2. After the tone, say "Re‐dial." Once connected, the person called will be heard through the audio speakers. . 7-89 Call Waiting Call waiting must be supported on the cell phone and enabled by the wireless service carrier. . Press b g to answer an incoming call when another call is active. The original call is placed on hold. Press b g again to return to the original call. To ignore the incoming call, no action is required. Press $ i to disconnect the current call and switch to the call on hold. Receiving a Call When an incoming call is received, the audio system mutes and a ring tone is heard in the vehicle... . . b g to answer the call. Press $ i to ignore a call. Press