2011 Chevrolet Volt Owner's Manual - Page 41

Keys, Doors and Windows 4. Press and hold the POWER O button on the center stack for two seconds. When the transmitter is programmed, the DIC will show that it is ready to program the next transmitter. 5. Remove the transmitter from the transmitter slot and press K on the transmitter. To program additional transmitters, repeat Steps 3 through 5. When all additional transmitters are programmed, press and hold the POWER O button for 10 seconds to exit programming mode. Programming without a Recognized Transmitter 2-5 3. Remove the rubber mat in the instrument panel storage. Extend the key blade on the new transmitter and insert the key blade into the transmitter slot. Non-Canadian (U.S.) owners are permitted to program a new transmitter to their vehicle when a recognized transmitter is not available. The Canadian regulations require that Canadian owners see their dealer for programming new transmitters when two recognized transmitters are not available. If there are no currently recognized transmitters available, follow this procedure to program up to five transmitters.