2010 Chrysler PT Cruiser Owner Manual - Page 25

24 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 9. Using the RKE transmitter to be programmed, press and release both the LOCK and UNLOCK buttons, 3. Fasten your seatbelt. (Fastening the seatbelt will cancel simultaneously. any chimes that may confuse you during this program10. A single chime will be heard. ming procedure.) 2. Enter your vehicle and close all doors. 4. Place the key into the ignition. 11. Within four seconds of hearing the chime, press and release the UNLOCK button on the RKE transmitter. 5. Turn the ignition to the ON position. Do not start the engine. 12. A single chime will be heard. 6. Press and hold the UNLOCK button on the RKE 13. Repeat steps 8 through 10 to program up to six additional RKE transmitters. transmitter. 7. After holding the UNLOCK button for four seconds, 14. Turn the ignition to the OFF position. also press the PANIC button within six seconds. 15. Your vehicle will remain in program mode up to 8. When a single chime is heard, release both buttons. 60 seconds from when the original chime was heard. The chime is an indication that you have successfully After 60 seconds, all programmed RKE transmitters entered program mode. All RKE transmitters that are to function normally. be programmed must be done so within 60 seconds of NOTE: If you do not have a programmed RKE transwhen the chime was heard. mitter, contact your authorized dealer for details.