2013 Chrysler 300 Owner Manual - Page 267

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 265 1. Cycle the ignition to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. 3. Simultaneously press and hold both the HomeLink® button you want to program and the hand-held transmitter button. 5. At the garage door opener motor (in the garage), locate the "LEARN" or "TRAINING" button. This can usually be found where the hanging antenna wire is attached to the garage door opener/device motor. Firmly press and release the "LEARN" or "TRAINING" button. On some garage door openers/devices there may be a light that blinks when the garage door opener/device is in the LEARN/TRAIN mode. 3 NOTE: You have 30 seconds in which to initiate the next 4. Continue to hold both buttons and observe the indi- step after the LEARN button has been pressed. cator light. The HomeLink® indicator will flash slowly 6. Return to the vehicle and press the programmed and then rapidly after HomeLink® has received the HomeLink® button twice (holding the button for two frequency signal from the hand-held transmitter. Reseconds each time). If the garage door opener/device lease both buttons after the indicator light changes activates, programming is complete. from slow to rapid. NOTE: If the garage door opener/device does not activate, press the button a third time (for two seconds) to complete the training.