2013 Chrysler 300 Owner Manual - Page 30

28 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE To Enter Remote Start Mode • The engine can be started two consecutive times (two 15-minute cycles) with the RKE transmitter. However, the ignition must be cycled to the RUN position before Press and release the REMOTE START button you can repeat the start sequence for a third cycle. on the RKE transmitter twice within five seconds. The vehicle doors will lock, parking To Exit Remote Start Mode Without Driving The lights will flash and the horn will chirp twice (if Vehicle programmed). Then, the engine will start and the vehicle Press and release the REMOTE START button one time or will remain in the Remote Start mode for a 15-minute allow the engine to run for the entire 15 minute cycle. cycle. NOTE: To avoid unintentional shutdowns, the system NOTE: will disable the one time press of the REMOTE START • If an engine fault is present or fuel level is low, the button for two seconds after receiving a valid Remote vehicle will start and then shut down in 10 seconds. Start request. • The park lamps will turn on and remain on during To Exit Remote Start Mode And Drive The Vehicle Remote Start mode. Before the end of 15 minute cycle, press and release the • For security, power window and power sunroof op- UNLOCK button on the RKE transmitter to unlock the eration (if equipped) are disabled when the vehicle is in the Remote Start mode.