2013 Chrysler 300 Owner Manual - Page 440

438 STARTING AND OPERATING Should this occur, you should stop as soon as possible and inflate the tires with a low pressure condition (those flashing or in a different color in the EVIC graphic) to the vehicle's recommended cold placard pressure inflation value as shown in the ЉInflate to XXЉ message. Once the system receives the updated tire pressures, the system will automatically update, the graphic display in the EVIC will stop flashing or change color back to the original color, and the TPM Telltale Light will turn off. The vehicle may need to be driven for up to 20 minutes above 15 mph (24 km/h) in order for the TPMS to receive this information. Service TPMS Warning a minimum of five seconds and then display dashes (- -) in place of the pressure value to indicate which sensor is not being received. If the ignition switch is cycled, this sequence will repeat, providing the system fault still exists. If the system fault no longer exists, the TPM Telltale Light will no longer flash, and the ЉSERVICE TPM SYSTEMЉ message will no longer display, and a pressure value will display in place of the dashes. A system fault can occur due to any of the following: 1. Signal interference due to electronic devices or driving next to facilities emitting the same radio frequencies as the TPM sensors. If a system fault is detected, the TPM Telltale Light will flash on and off for 75 seconds and then remain on solid. 2. Installing aftermarket window tinting that contains materials that may block radio wave signals. The system fault will also sound a chime. In addition, the EVIC will display a ЉSERVICE TPM SYSTEMЉ message for 3. Accumulation of snow or ice around the wheels or wheel housings.