2013 Chrysler 300 Owner Manual - Page 270

268 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 3. Continue to press and hold the HomeLink® button, • To program the two remaining HomeLink® buttons, while you press and release ("cycle"), your hand-held repeat each step for each remaining button. DO NOT transmitter every two seconds until HomeLink® has erase the channels. successfully accepted the frequency signal. The indiIf you unplugged the garage door opener/device for cator light will flash slowly and then rapidly when programming, plug it back in at this time. fully trained. Reprogramming A Single HomeLink® Button 4. Watch for the HomeLink® indicator to change flash rates. When it changes, it is programmed. It may take To reprogram a channel that has been previously trained, up to 30 seconds or longer in rare cases. The garage follow these steps: door may open and close while you are programming. 1. Cycle the ignition to the ON/RUN position. 5. Press and hold the programmed HomeLink® button 2. Press and hold the desired HomeLink® button until and observe the indicator light. the indicator light begins to flash after 20 seconds. Do • If the indicator light stays on constantly, programnot release the button. ming is complete and the garage door/device should activate when the HomeLink® button is pressed.