2013 Chrysler 300 Owner Manual - Page 368

366 STARTING AND OPERATING 4. If you wish to stop the cranking of the engine prior to the engine starting, press the button again. NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal. To Turn Off The Engine Using ENGINE START/STOP Button ENGINE START/STOP button is pressed once, the EVIC (if equipped) will display a "Vehicle Not In Park" message and the engine will remain running. Never leave a vehicle out of the PARK position, or it could roll. NOTE: If the ignition switch is left in the ACC or RUN (engine not running) position and the transmission is in PARK, the system will automatically time out after 30 1. Place the shift lever in PARK, then press and release minutes of inactivity and the ignition will switch to the the ENGINE START/STOP button. OFF position. 2. The ignition switch will return to the OFF position. ENGINE START/STOP Button Functions - With Driver's Foot OFF The Brake Pedal (In PARK Or 3. If the shift lever is not in PARK, the ENGINE START/ NEUTRAL Position) STOP button must be held for two seconds and vehicle speed must be above 5 mph (8 km/h) before the The ENGINE START/STOP button operates similar to an engine will shut off. The ignition switch position will ignition switch. It has four positions, OFF, ACC, RUN remain in the ACC position until the shift lever is in and START. To change the ignition switch positions PARK and the button is pressed twice to the OFF without starting the vehicle and use the accessories position. If the shift lever is not in PARK and the follow these steps.