2013 Chrysler 300 Owner Manual - Page 269

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 267 Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transReprogramming A Single HomeLink® Button mission - which may not be long enough for HomeLink® To reprogram a channel that has been previously trained, to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to follow these steps: time-out in the same manner. 1. Cycle the ignition to the ON/RUN position. It may be helpful to unplug the device during the cycling 2. Press and hold the desired HomeLink® button until process to prevent possible overheating of the garage the indicator light begins to flash after 20 seconds. Do door or gate motor. not release the button. 1. Cycle the ignition to the ON/RUN position. 3. Without releasing the button proceed with "Programming A Non-Rolling Code" Step 2 and follow all 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you wish to program while remaining steps. keeping the HomeLink® indicator light in view. • If the indicator light stays on constantly, programming is complete and the garage door/device should activate when the HomeLink® button is pressed. • To program the two remaining HomeLink® buttons, repeat each step for each remaining button. DO NOT erase the channels. Canadian/Gate Operator Programming For programming transmitters in Canada/United States that require the transmitter signals to "time-out" after several seconds of transmission. 3