2013 Chrysler 300 Owner Manual - Page 513

MAINTAINING YOUR VEHICLE 511 Adding Washer Fluid The windshield washer fluid reservoir is located in the front of the engine compartment. Be sure to check the fluid level at regular intervals. Fill the reservoir with windshield washer solvent (not radiator antifreeze) and operate the system for a few seconds to flush out the residual water. the Electronic Vehicle Information Center (EVIC) (if equipped). WARNING! Commercially available windshield washer solvents are flammable. They could ignite and burn you. Care must be exercised when filling or working around the washer solution. When refilling the washer fluid reservoir, apply some washer fluid to a cloth or towel and wipe the wiper Exhaust System blades clean. This will help blade performance. To prevent freeze-up of your windshield washer system The best protection against carbon monoxide entry into in cold weather, select a solution or mixture that meets or the vehicle body is a properly maintained engine exhaust exceeds the temperature range of your climate. This system. rating information can be found on most washer fluid If you notice a change in the sound of the exhaust system; containers. or if the exhaust fumes can be detected inside the vehicle; The fluid reservoir will hold nearly 1 gal (4 L) of washer or when the underside or rear of the vehicle is damaged; fluid when the message "Low Washer Fluid" appears in 7