2011 Jeep Wrangler Owner Manual - Page 20

18 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 4. Insert a blank Sentry Key௡ into the ignition switch. Turn the ignition switch to the ON/RUN position within 60 seconds. After 10 seconds, a single chime will sound. In addition, the Vehicle Security Light will stop flashing. To indicate that programming is complete, the Vehicle Security Light will turn on again for three seconds and then turn off. reprogrammed. All vehicle keys must be taken to an authorized dealer at the time of service to be reprogrammed. General Information The Sentry Key௡ system complies with FCC rules Part 15 and with RSS-210 of Industry Canada. Operation is subject to the following conditions: The new Sentry Key௡ is programmed. The Remote • This device may not cause harmful interference. Keyless Entry (RKE) transmitter will also be pro• This device must accept any interference that may be grammed during this procedure. received, including interference that may cause undeRepeat this procedure to program up to eight keys. If you sired operation. do not have a programmed Sentry Key௡, contact your authorized dealer for details. VEHICLE SECURITY ALARM - IF EQUIPPED NOTE: If a programmed key is lost, see your authorized The Vehicle Security Alarm monitors the vehicle doors, dealer to have all remaining keys erased from the sys- swing gate, and ignition for unauthorized operation. tem's memory. This will prevent the lost key from While the Vehicle Security Alarm is armed, interior starting your vehicle. The remaining keys must then be switches for door locks are disabled. The Vehicle Security Alarm provides both audible and visible signals when