2011 Jeep Wrangler Owner Manual - Page 392

390 STARTING AND OPERATING This system is controlled by the SWAY BAR switch Indicator Light" will flash during activation transition, or located on the instrument panel (to the left of the steering when activation conditions are not met. The stabilizer/ sway bar should remain in on-road mode during normal column). driving conditions. WARNING! Do not disconnect the stabilizer bar and drive on hard-surfaced roads or at speeds above 18 mph (29 km/h); you may lose control of the vehicle, which could result in serious injury. The front stabilizer bar enhances vehicle stability and is necessary for maintaining control of the vehicle. The system monitors vehicle speed and will attempt to reconnect the stabilizer bar at speeds over 18 mph (29 km/h). This is indicated by a flashing or solid "Sway Bar Indicator Light." Once vehicle speed is reduced below 14 mph (22 km/h), the system will once again attempt to return to off-road mode. Sway Bar Switch Press the SWAY BAR switch to activate the system. Press the switch again to deactivate the system. The "Sway Bar Indicator Light" (located in the instrument cluster) will illuminate when the bar is disconnected. The "Sway Bar