2011 Jeep Wrangler Owner Manual - Page 38

36 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 6. The doors were not previously locked using the power 2. Within 15 seconds, cycle the ignition switch between door lock switch or Remote Keyless Entry (RKE) LOCK and ON/RUN and then back to LOCK four times ending up in the LOCK position (do not start the engine). transmitter 3. Within 30 seconds, press the power door LOCK switch Automatic Door Locks Programming - to lock the doors. If Equipped The Automatic Door Locks feature can be enabled or 4. A single chime will indicate the completion of the disabled as follows: programming. • For vehicles equipped with the Electronic Vehicle 5. Repeat these steps if you want to return this feature to Information Center (EVIC), refer to "Electronic Vehicle its previous setting. Information Center (EVIC) - If Equipped/Personal Settings (Customer-Programmable Features)" in "Un- NOTE: derstanding Your Instrument Panel" for further infor- • If you do not hear the chime it means that the system did not enter the programming mode and you will mation. need to repeat the procedure. • For vehicles not equipped with the EVIC, perform the following procedure: • Use the Automatic Door Locks feature in accordance with local laws. 1. Close all doors and place the key in the ignition switch.