2011 Jeep Wrangler Owner Manual - Page 453
2011 Jeep Wrangler Manual
Page 453 highlights
STARTING AND OPERATING 451 2. Installing some form of aftermarket window tinting that affects radio wave signals. 3. Lots of snow or ice around the wheels or wheel • If your vehicle is not equipped with a matching housings. full-size spare wheel and tire assembly, it does not 4. Using tire chains on the vehicle. have a tire pressure monitoring sensor in the spare tire. The TPMS will not be able to monitor the tire pressure. 5. Using wheels/tires not equipped with TPM sensors. If you install the spare tire in place of a road tire that NOTE: has a pressure below the low-pressure warning limit, • If your vehicle is equipped with a matching full-size upon the next ignition key cycle, a chime will sound spare wheel and tire assembly, it has a tire pressure and the "Tire Pressure Monitoring Telltale Light" will monitoring sensor, and can be monitored by the Tire turn ON. After driving the vehicle for up to 20 minutes Pressure Monitoring System (TPMS). In the event that above 15 mph (24 km/h), the "Tire Pressure Monitorthe matching full-size spare tire is swapped with a low ing Telltale Light" will flash on and off for 75 seconds pressure road tire, the next ignition key cycle will still and then remain on solid. For each subsequent ignition show the "Tire Pressure Monitoring Telltale Light" to key cycle, a chime will sound and the "Tire Pressure be ON, and a chime to sound. Driving the vehicle for Monitoring Telltale Light" will flash on and off for up to 20 minutes above 15 mph (24 km/h) will turn 75 seconds and then remain on solid. Once you repair or replace the original road tire, and reinstall it on the OFF the "Tire Pressure Monitoring Telltale Light" as long as none of the road tires are below the low pressure warning threshold. 5