2011 Jeep Wrangler Owner Manual - Page 57

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 55 out only the amount of webbing necessary to comfort- 3. Allow the belt to retract. As the belt retracts, you will ably wrap around the occupant's mid-section. Slide the hear a clicking sound. This indicates the safety belt is now in the Automatic Locking Mode. latch plate into the buckle until you hear a Љclick.Љ Automatic Locking Retractor Mode (ALR) - If Equipped In this mode, the shoulder belt is automatically prelocked. The belt will still retract to remove any slack in the shoulder belt. The Automatic Locking Mode is available on all passenger-seating positions with a combination lap/shoulder belt. Use the Automatic Locking Mode anytime a child safety seat is installed in a seating position that has a belt with this feature. Children 12 years old and under should always be properly restrained in the rear seat. How To Engage The Automatic Locking Mode 1. Buckle the combination lap and shoulder belt. 2. Grasp the shoulder portion and pull downward until the entire belt is extracted. How To Disengage The Automatic Locking Mode Unbuckle the combination lap/shoulder belt and allow it to retract completely to disengage the Automatic Locking Mode and activate the vehicle sensitive (emergency) locking mode. 2 WARNING! • The belt and retractor assembly must be replaced if the seat belt assembly Automatic Locking Retractor (ALR) feature or any other seat belt function is not working properly when checked according to the procedures in the Service Manual. • Failure to replace the belt and retractor assembly could increase the risk of injury in collisions.