1994 Pontiac Firebird Owner's Manual - Page 83

1994 Pontiac Firebird Manual

Page 83 highlights

Features and Controls Reverse the steps above to install the T-top panels. When installing panels, be sure to align weatherstrips properly. Panels incorrectly installed may leak. NOTICE: High pressure car washes may cause water to enter your vehicle. Never spray water directly at the roof panel joints. This will cause leaks. r-Top Sunshades I . Start with the panel marked "DRIVEE FRONT." Unlatch the driver-side T-top, raise it halfway and close the latch handle. 2. With the top raised and resting on the center toof rail, slide the flat edge of the sunshade panel (with the vinyl side to the glass) between the glass and plastic trim, making sure the edge marked "DRIVER FRONT." is pointing to the front of the vehicle. 3. Open the latch and closethe T-top. Check to see if there are any gaps showing. Unlatch the T-top and adjust the sunshade required. as 4. Once the sunshadeis installed properly, you can stick the Velcro@ buttons on the glass for a proper fit every time you install the sunshades. To do this, first remove the T-top with the sunshade installed and place it upside down a table or bench. on Take care not to scratch the glass. ..A2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
  • 257
  • 258
  • 259
  • 260
  • 261
  • 262
  • 263
  • 264
  • 265
  • 266
  • 267
  • 268
  • 269
  • 270
  • 271
  • 272
  • 273
  • 274
  • 275
  • 276
  • 277
  • 278
  • 279
  • 280
  • 281
  • 282
  • 283
  • 284
  • 285
  • 286
  • 287
  • 288
  • 289
  • 290

Features
and
Controls
Reverse the steps above to install the
T-top
panels.
When installing panels, be sure to align
weatherstrips properly. Panels incorrectly
installed may leak.
NOTICE:
High pressure car washes may cause
water to enter your vehicle. Never
spray water directly at the roof
panel
joints.
This
will cause leaks.
r-Top
Sunshades
I .
2.
Start with the panel
marked
“DRIVEE
FRONT.”
Unlatch
the driver-side
T-top, raise it halfway
and close the
latch handle.
With
the
top raised and
resting on the
center
toof
rail, slide the flat edge
of
the sunshade panel (with the vinyl
side to the glass) between
the glass
and plastic trim, making sure the
edge marked
“DRIVER
FRONT.”
is
pointing to the front of the
vehicle.
3.
4.
Open
the
latch
and
close
the
T-top.
Check to see if there are any
gaps
showing.
Unlatch
the T-top
and
adjust
the
sunshade
as required.
Once the
sunshadeis installed
properly,
you
can
stick
the
Velcro@
buttons
on the glass for a proper fit
every
time
you
install
the
sunshades.
To do this, first remove
the
T-top
with
the
sunshade
installed
and
place
it
upside
down on a table or bench.
Take care not to scratch
the
glass.
..A2