2006 Subaru Impreza Owner's Manual - Page 101

2-14 Keys and doors cating that the system is now deactivated. If the system was previously deactivated: The odometer/trip meter screen displays “AL on” and the horn sounds once, indicating that the system is now activated. 4. Make sure that the engine hood (and the trunk lid) are locked. 5. Close all doors (and the rear gate on the Wagon). NOTE You may have the above setting change done by your SUBARU dealer. To stop the alarm Do any of the following operations: Press any button on the remote transmitter. Cycle the ignition switch from the “LOCK” to “ON” position three times within 5 seconds. To arm the system using remote transmitter 1. Close all windows and the moonroof (if so equipped). 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. If you have accidentally triggered the alarm system : Press to Arm the system. : Press to Disarm the system. 200808 Arming the system 6. Briefly press the “ ” button (for less than two seconds). All doors (and the rear gate on the Wagon) will lock, an electronic chirp will sound once, the turn signal lights will flash once, and the indicator lights will start flashing rapidly. After rapid flashing for 30 seconds (standby time), the indicator lights will then flash slowly (twice approximately every two seconds), indicating that the system has been armed for surveillance. If any of the doors, (rear gate or trunk lid) is not fully closed, an electronic chirp sounds five times, the turn signal lights flash five times to alert you that the doors (or the rear gate) are not properly closed. When you close the door, the system will Security indicator light 200873