2006 Subaru Impreza Owner's Manual - Page 146
2006 Subaru Impreza Manual
Page 146 highlights
Instruments and controls 3-33 cover the sensors with stickers, or other similar items. Periodically wipe the sensors clean using a piece of dry soft cotton cloth or an applicator. Compass zone adjustment 3 13 4 12 11 exit the zone setting mode. Compass calibration 1. For optimum calibration, switch off all nonessential electrical accessories (rear window defogger, heater/air conditioning system, spotlight, etc.) and ensure all doors are shut. 2. Drive to an open, level area away from large metallic objects or structures and make certain the ignition switch is in the ON position. 3. Press and hold the left button for 3 seconds then release, and the compass will enter the calibration mode. CAL and direction will be displayed. 4. Drive slowly in a circle until CAL disappears from the display (approximately two or three circles). The compass is now calibrated. 5. Further calibration may be necessary should outside. Influences cause the mirror to read inaccurately. You will know that this has occurred if your compass begins to read in only limited directions. Should you encounter this situation, return to step one of the above procedure and recalibrate the mirror. Outside mirrors 5 6 7 8 9 10 1. The zone setting is factory preset to Zone 8. Refer to the Compass calibration zone map shown above or one attached to the end of this manual to verify that the compass zone setting is correct for your geographical location. 2. Press and hold the right button for 3 seconds then release, and the word ZONE will briefly appear and then the zone number will be displayed. 3. Press the right-hand button repeatedly to cycle the display through all possible zone settings. Stop cycling when the correct zone setting for your location is displayed. 4. Releasing the button for 3 seconds will Compass calibration zones 300580 300146 Convex mirror (passenger side) Objects look smaller in a convex mirror and farther away than when viewed in a flat mirror. Do not use the convex mirror to judge the distance of vehicles behind you when changing lanes. Use the inside mirror (or glance backwards) to determine the actual size and distance of objects that you view in convex mirror. CONTINUED