2006 Subaru Impreza Owner's Manual - Page 102

Keys and doors 2-15 automatically arm and doors will automatically lock. To arm the system using power door locking switches 1. Close all windows. 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood is locked. 5. Close the doors (and the rear gate on the Wagon) but leave only the driver’s door or the front passenger’s door open. sound once, the turn signal lights will flash once, and the indicator lights will start flashing rapidly. After rapid flashing for 30 seconds (standby time), the indicator lights will then flash slowly (twice approximately every two seconds), indicating that the system has been armed for surveillance. “ON” position. The engine does not start even when the ignition switch is turned to the “START” position once the alarm system has been triggered. Briefly press the “ ” button (for less than two seconds) on the remote transmitter. The driver’s door will unlock, an electronic chirp will sound twice, the turn signal lights will flash twice and the indicator light will go off. NOTE Disarming the system 6. Push the front side (“LOCK” side) of the power door locking switch to set the door locks. 7. Close the door. An electronic chirp will The system can be armed even if the engine hood, the windows and/or moonroofs are opened. Always make sure that they are fully closed before arming the system. The 30-second standby time can be eliminated if you prefer. Have it performed by your SUBARU dealer. The system is in the standby mode for a 30-second period after locking the doors with the remote transmitter. The security indicator light will flash at short intervals during this period. If any of the following actions is done during the standby period, the system will not switch to the surveillance state. Doors are unlocked using the remote transmitter. Any door (including the rear gate of a Wagon or the trunk of a Sedan) is opened. Ignition switch is turned to the NOTE (Models with immobilizer) If your vehicle is equipped with an immobilizer, the immobilizer’s function will cause the security indicator light to flash (approximately once every three seconds) even after the system is disarmed. NOTE The system can be disarmed by the following method, too. Cycle the ignition switch from the “LOCK” to the “ON” position three times within 5 seconds. Emergency disarming If you cannot disarm the system using the – CONTINUED –