2006 Subaru Impreza Owner's Manual - Page 96

Keys and doors 2-9 seconds after Step 3. 5. While still holding down the “UNLOCK” side of the power door locking switch, close the driver’s door once within 10 seconds after Step 4. 6. The turn signal lights flashes 3 times to indicate completion of the setting. To replace the battery: 0 1 NOTE If you do not close the driver’s door within 10 seconds after Step 4, a flash of the turn signal lights will signal timeout. If this happens, repeat the whole procedure from Step 1. You may have the above settings done by your SUBARU dealer. When the transmitter battery begins to get weak, transmitter range will begin to decrease. Replace the battery as soon as possible. Replacing the battery 1. Open the transmitter case using a flathead screwdriver. 200809 3. Replace with a new battery (Type CR2025 or equivalent) making sure to install the new battery with the negative (–) side facing up. 4. Reinstall the back half of the transmitter case by snapping it back on. After the battery is replaced, the transmitter must be synchronized with the keyless entry system’s control unit. Press either the “ ” or “ ” button six times to synchronize the unit. 1) Negative (–) side facing up 200717 2. Remove the old battery from the holder. 200716 Do not let dust, oil or water get on or in the transmitter when replacing the battery. – CONTINUED –