2006 Subaru Impreza Owner's Manual - Page 97
2006 Subaru Impreza Manual
Page 97 highlights
2-10 Keys and doors Be careful not to damage the printed circuit board in the transmitter when replacing the battery. Programming transmitter codes into system: To register a new transmitter with the keyless entry system, it is necessary to program the transmitters code (identification number) into the system. A label showing the code is affixed to the bag containing the transmitter, and another is affixed to the circuit board inside the transmitter. If there is no bag, open the transmitter case and make a note of the eight-digit number. Program the number into the system in accordance with the following procedure: 1. Firmly close the doors and the rear gate, or trunk lid. 2. Open the drivers door, sit on the drivers seat, and close the door. 3. Perform the following steps within 45 seconds. If you lose a transmitter or want to purchase additional transmitters (up to four can be programmed), you should re-program all of your transmitters for security reasons. It is recommended that you have your dealer program all of your transmitters into your system. Replacing lost transmitters Programming the transmitters The keyless entry system is equipped with a special code learning feature that allows you to program new transmitter codes into the system or to delete old ones. The system can learn up to four unique transmitter codes. The four transmitter codes may be the same or different. Bag containing transmitter 200718 Transmitter circuit board 200719 1) Open and close the drivers door once. 200813