2006 Subaru Impreza Owner's Manual - Page 84

Side airbag sensor (Center pillar right hand side) Side airbag sensor (Center pillar left hand side) Side airbag module (Driver’s side) Side airbag module (Front passenger’s side) Seatbelt pretensioner (Driver’s side) Seatbelt pretensioner (Front passenger’s side) Seatbelt buckle switch (Driver’s side) Seatbelt buckle switch (Front passenger’s side) Driver’s seat position sensor Front passenger’s seatbelt tension sensor Front passenger’s occupant detection system weight sensor Front passenger’s occupant detection control module Front passenger’s frontal airbag ON and OFF indicator All related wiring If the warning light exhibits any of the following conditions, there may be a malfunction in the seatbelt pretensioners and/or SRS airbag system. Immediately take your vehicle to your nearest SUBARU dealer to have the system checked. Unless checked and properly repaired, the seatbelt pretensioners and/or SRS airbag will not operate properly in the event of a collision, which may increase the risk of injury. Flashing or flickering of the warning light No illumination of the warning light when the ignition switch is first turned to the “ON” position Continuous illumination of the warning light Illumination of the warning light while driving SRS airbag system servicing When discarding an airbag module or scrapping the entire vehicle damaged by a collision, consult your SUBARU dealer. Seat, seatbelt and SRS airbags 1-57 The SRS airbag has no user-serviceable parts. Do not use electrical test equipment on any circuit related to the SRS airbag system. For required servicing of the SRS airbag, see your nearest SUBARU dealer. Tampering with or disconnecting the system’s wiring could result in accidental inflation of the SRS airbag or could make the system inoperative, which may result in serious injury. The wiring harnesses of the SRS airbag system are covered with yellow insulation and system connectors are yellow for easy identification. – CONTINUED –