2006 Subaru Impreza Owner's Manual - Page 289
2006 Subaru Impreza Manual
Page 289 highlights
11-10 Maintenance and service Oil filter color Black White Part number 15208AA100 15208AA09A Amount of rotation 2/3 3/4 rotation 1 rotation 11.Reinstall under cover. 12.Pour engine oil through the filler neck. Oil capacity (guideline): 4.2 US qt (4.0 liters, 3.5 Imp qt) Never over tighten the oil filter because that can result in an oil leak. Thoroughly wipe off any engine oil that has spilled over the exhaust pipe and/or under-cover. If left unremoved, the oil could catch fire. Be careful not to spill engine oil when adding it. If oil touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. 3 C ON VI B00446 refilling the engine with oil, therefore, you must the dipstick to confirm that the level is correct. 13.Start the engine and make sure that no oil leaks appear around the filters rubber seal and drain plug. 14.Run the engine until it reaches the normal operating temperature. Then stop the engine and wait a few minutes to allow the oil drain back. Check the oil level again and if necessary, add more engine oil. container. 1 2 A ERVICE S I S P SAE 5W-30 R GY The oil quantity indicated above is only guideline. The necessary quantity of oil depends on the quantity of oil that has been drained. The quantity of drained oil differs slightly depending on the temperature of the oil and the time the oil is left flowing out. After Oil grade: Recommended grade and viscosity API Service label 1) Indicates the oil quality by API designations 2) Indicates the SAE oil viscosity grade 3) Indicates that the oil has fuel saving capabilities These recommended oil grades can be identified by looking for either or both of the following marks displayed on the oil ILSAC GF-4, which can be identified with the ILSAC certification mark (Starburst mark) or API classification SM with the words ENERGY CONSERVING NG R NE