2011 Subaru Outback Owner's Manual - Page 106

2-18 Keys and doors start flashing rapidly. After rapid flashing for 30 seconds (standby time), the security indicator light will then flash slowly (twice approximately every 2 seconds), indicating that the system has been armed for surveillance. - Doors are unlocked using the remote transmitter. - Any door (including the rear gate (Outback) or the trunk (Legacy)) is opened. - Ignition switch is turned to the "ON" position. & Valet mode When you choose the valet mode, the alarm system does not operate. In valet mode, the remote transmitter is used only for locking and unlocking the doors and rear gate (Outback) and panic activation. To enter the valet mode, change the setting of your vehicle's alarm system for deactivation mode. Refer to "Activating and deactivating the alarm system" F216. The security indicator light will continue to flash once every 3 seconds indicating that the system is in the valet mode. To exit valet mode, change the setting of your vehicle's alarm system for activation mode. Refer to "Activating and deactivating the alarm system" F2-16. NOTE . The system can be armed even if the engine hood, the windows and/or moonroof are open. Always make sure that they are fully closed before arming the system. . The 30-second standby time can be eliminated if you prefer. Have it performed by your SUBARU dealer. . If your vehicle is a Legacy and you open the trunk using the remote transmitter's " " button with the alarm system armed, the system will be temporarily placed in a standby state. The system will go back to the surveillance state upon locking the trunk. . The system is in the standby mode for a 30-second period after locking the doors with the remote transmitter. The security indicator light will flash at short intervals during this period. . If any of the following actions is done during the standby period, the system will not switch to the surveillance state. & Disarming the system Briefly press the " " button (for less than 2 seconds) on the remote transmitter. The driver's door will unlock, an electronic chirp will sound twice, the turn signal lights will flash twice and the security indicator light will turn off. To unlock all other doors and the rear gate (Outback), briefly press the " " button a second time within 5 seconds. ! Emergency disarming If you cannot disarm the system using the transmitter (i.e. the transmitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the transmitter. The system can be disarmed if you turn the ignition switch from the "LOCK" to the "ON" position with a registered key. & Passive arming When passive arming mode has been programmed by the dealer, arming of the system is automatically accomplished without using the remote transmitter. Note that in this mode, DOORS MUST BE MANUALLY LOCKED. ! To enter the passive mode If you wish to program the passive arming mode, have it done by your SUBARU dealer.