2011 Subaru Outback Owner's Manual - Page 193
2011 Subaru Outback Manual
Page 193 highlights
Audio 5-17 pressing the "FOLDER" button " " changes the category up by one step. Pressing " " changes the category down by one step. When a category is selected, pressing the "SEEK" button selects channels only within the selected category. The control function returns to the normal mode after approximately 10 seconds. ! Channel scan the ALL SCAN mode, the radio scans all channels. In both SCAN modes, the radio will stop at the station for 5 seconds while displaying the channel number, after which scanning will continue until the entire channel has been scanned from the low end to the high end. Press the "SCAN" button again to cancel the SCAN mode and to stop on any displayed channel. ! How to preset channels 1. Press the "SAT" button to select SAT1, SAT2 and SAT3 reception. 2. Select the desired channel. 3. Press one of the preset buttons for more than 1.5 seconds to store the channel. If the button is pressed for less than 1.5 seconds, the preceding selection will remain in memory. & Channel preset NOTE If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all channels stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset channels. ! Selecting preset channels Presetting a channel with a preset button allows you to select that channel in a single operation. Up to six SAT1, SAT2 and SAT3 channels each may be preset. If you press the "SCAN" button while the radio is in the category search mode, the radio turns to the category SCAN mode. In the category SCAN mode, the radio scans only channels in the selected category. If you press the "SCAN" button while the radio is not in the category search mode, the radio turns to the ALL SCAN mode. In Preset buttons - CONTINUED -