2011 Subaru Outback Owner's Manual - Page 147
2011 Subaru Outback Manual
Page 147 highlights
Instruments and controls 3-29 & Daytime running light system WARNING The brightness of the illumination of the high beam headlights is reduced by the daytime running light system. The light switch must always be turned to the " " position when it is dark outside. The high beam headlights will automatically illuminate at reduced brightness when the engine has started, under the following conditions. . The parking brake is fully released. . The light switch is in the "OFF" or " " position. . The light switch is in the "AUTO" position and the headlights do not turn on automatically. . The select lever is in a position other than the "P" position (AT and CVT models). parking brake is applied, the daytime running lights continue to illuminate until the ignition switch is returned to the "LOCK" position. Turn signal lever To activate the right turn signal, push the turn signal lever up. To activate the left turn signal, push the turn signal lever down. When the turn is finished, the lever will return automatically. If the lever does not return after cornering, return the lever to the neutral position by hand. To signal a lane change, push the turn signal lever up or down slightly and hold it during the lane change. The turn signal indicator lights will flash in the direction of the turn or lane change. The lever will return automatically to the neutral position when you release it. NOTE . When the light switch is in the " " position, the front side marker lights, tail lights and license plate lights are illuminated. . After turning on the ignition switch to the "ON" position, even if the