2011 Subaru Outback Owner's Manual - Page 237

Interior equipment 6-19 Rear view camera (if equipped) A rear view camera is attached to the trunk lid (Legacy) or rear gate (Outback). When the ignition switch is "ON" and the shift lever (MT models) or select lever (AT or CVT models) is set to "R", the rear view camera automatically displays the rear view image from the vehicle on the navigation monitor. electric shock. CAUTION . If your vehicle is washed with a high-pressure washer, do not allow water to contact the camera directly. Entry of water in the camera lens may result in condensation, malfunction, fire or electric shock. . Since the camera is a precision device, do not subject it to strong impacts. Otherwise, malfunction, fire or electric shock may occur. . If mud or snow sticks to or is frozen on the camera, you must be very careful removing it. Otherwise, damage done to the camera may cause a fire or electric shock. Pour water or lukewarm water over the camera to remove mud and ice, and wipe it with a soft, dry cloth. . Do not put a flame close to the camera or wiring. Otherwise, damage or fire may occur. . When replacing the fuse, be sure to use a fuse with the specified rating. Use of a fuse with a different rating may result in a - CONTINUED - WARNING . Since the rear view camera uses a wide-angle lens, the image on the monitor is different from the actual view in terms of distance. . Since the range of the image on the monitor is limited, you should always check the rear view and the surrounding area with your eyes and mirrors, and move backward at a slow speed. Moving backward only by checking the monitor could cause an accident. . Do not disassemble or modify the camera, switch or wiring. If smoke comes out or you smell a strange odor, stop using the rear view camera immediately. Contact your SUBARU dealer for an inspection. Continued use may result in accident, fire or Legacy Outback